PIAGGIO NRG POWER PUREJET, Руководство по ремонту, Страница: 54 / 248

Recharge system voltage check
Connect an ammeter induction clamp to the volt-
age regulator positive cable. Measure the battery
voltage and turn on the lights with the engine off
and wait until the voltage settles at around 12 volts.
Start the engine and measure the current distrib-
uted by the circuit with the lights on and engine at
high rpm.
If the current value is less than 10A, repeat the test
using a new regulator and/or stator instead.
Starter motor
Specifications
- Rated voltage 12V.
- Rated power 0.25 kW.
- Left rotation viewed from pinion side.
- Connection to engine with pinion and crown
wheel on transmission side crankshaft.
- Control with button
Tests to perform to check the electrical starter
Static test
Remove the left side panel.
Check the resistance of the induced brush unit.
Reference value: < or equal to 1 Ohm
- Use a lift to adequately support the vehicle.
- Remove the stand and support.
- Use a multimeter to check the continuity of the
positive and negative power supply cable.
- Make sure the connections are good.
If no faults are found, replace the starter.
Specific tooling
020331Y Digital multimeter
Electrical system
NRG Power Purejet
ELE SYS - 10