Philips SOPHO 2000 IPS, Руководство пользователя

Страница: 367 / 880

– 349 –
NWA-008845-001 Rev.5.0
32ch1006.fm
To provide Do Not Disturb group set/cancel at specified timing in advance:
[Series 3300 software required]
AP Initialization (PN-AP00-B/PN-AP00-D with MRCA program)
This section explains the data assignment to make the AP active.
You can skip the data assignment explained on this section, if one of the following AP related features has
been activated; Station Message Detail Recording (SMDR) with NEAX 2400 IMS Format, Message Cen-
ter Interface (MCI) or Do Not Disturb group set/cancel at specified timing in advance. You can distinguish
whether the AP is active or not by the RUN lamp indication. The RUN lamp flashes on green color when
the AP is in active.
When you install the AP00 at first time, you should assign the data shown below.
DESCRIPTION DATA
Assign an AP number to the AP00 card. The
AP number must match the SENSE switch set-
ting on the AP00 card. •
(1)
(2)
Y=0
04-15, 20-31: AP No.
45: PN-AP00-B/PN-AP00-D card with
MRCA program
On the AP00 card, set SW1 switch as shown
below.
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
Load the initial data into the AP00 card.
On the AP00 card, set the SW1 switch as
shown below.
(1)
(2) 0000
CCC
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
START
CM05
INITIAL
SW 1
ON
: POSITION TO BE SET
4
3
2
1
CMDD99
AP OFF LINE
SW 1
ON
: POSITION TO BE SET
4
3
2
1
END
JULY/01/2006
DO NOT DISTURB