17
INSTALLATION
Installation
1. Remove the packing tape and clean up.
Remove all the tapes securing the doors and the inner attachments. Open the doors to ventilate the
chamber for a while. If the outer panels are dirty, use a cloth to wipe them with a diluted neutral detergent
(Undiluted detergent can damage the plastic components. For the dilution, refer to the instructions on the
detergent).
Wipe off the residual detergent with a piece of gauze moistened with water and then wipe off any moisture
with a dry cloth.
Note:
Remove the cable tie around the power supply cord to prevent corrosion of the cord coating.
2. Remove inner attachments.
(1) Lift the fan cover and pull it toward you to remove it
(Fig. 1).
(2) Lift the duct and remove it from the inner pins (Fig. 2).
3.
Connect the gas injection nozzle.
When controlling O
2
density in the chamber, connect the
gas injection nozzle to the gas injection port by using the
included gas injection nozzle tube (Fig. 3).
4. Install inner attachment.
(1) Install the duct removed in the above (2) of step 2.
Note:
When installing the duct, make sure that the four
pins are inserted into the four holes of the duct.
(2) Install the fan cover removed in the above (1) of step 2.
Note:
When installing the fan cover, make sure that two
upper hooks are inserted into the duct holes.
(3) Install the humidifying pan (Fig. 4).
(4) Install the two trays (Fig. 4).
Note:
Position the trays with the front edge bent down.
Gas injection
nozzle tube
Fig.3
Fig.1
Fig.2
Gas
injection
nozzle
Gas injection port
2 trays
Humidifying
pan
Fig.4
Fan cover
Duct
