Peterbilt 325 2017, Руководство оператора

Страница: 20 / 392

CAB AND FRAME ACCESS
Batteries
The key fob uses one CR2032,
3V battery. Batteries should last
approximately three years, depending
on use. Consistently reduced range
is an indicator that the battery needs
replacement. Batteries are available
at most discount, hardware and drug
stores.
The battery can be accessed by
removing the cover of the key fob.
After a new battery is installed, the
key fob must be synchronized with the
vehicle.
Synchronization
The key fob may need to be
synchronized to the truck when the
battery is replaced or when the key fob
has not been used for an extended
period of time.
To Synchronize A Key Fob
1. Hold the key fob near the receiver
which is located behind the
speedometer and tachometer.
2. Press and hold both the Lock and
Unlock buttons at the same time
for approximately 7 seconds.
3. When the key fob is
resynchronized, the doors
will lock then immediately unlock.
4. If the fob fails to synchronize,
it could be programmed to a
different truck or could have failed.
Contact your dealer to re-program
your key fob.
Climbing Onto the Deck
Plate
WARNING!
When you are climbing onto and
off the deck plate, maintain at least
three points of contact with your
hands on the grab handles and your
feet on the steps. Always face to-
ward the vehicle when entering or
exiting the cab and look where you
are going. Failure to comply may
result in death or personal injury.
WARNING!
When stepping onto a surface to en-
ter the cab or access the deck plate,
only use the steps and grab han-
dles installed and designed for that
purpose. Failure to use the proper
steps and grabhandles could cause
a fall which may result in death or
personal injury.
1-14
Y53-6060-1C1 (03/17)
1