PERCo IC-05, Руководство по сборке и эксплуатации

Страница: 19 / 34

Assembly and Operation Manual
18
Table 2. The components list of the connection layout for IC-05
Legend Item Qty
A1
IC-05
card capture reader 1
A2 Card capture reader control board 1
A3* Reader installed in a card capture reader (direction B) 1
A4* Reader for opposite to the card capture reader direction (direction A) 1
A5* ACS-controller 1
A6* Power supply 12 VDC/2.5A 1
1* Card capture reader power cable 1
2* Cable for ACS-controller connection 1
3* Cable for connection of the reader installed in a card capture reader 1
* - equipment is not included in the standard delivery set.
9 OPERATION INSTRUCTIONS
When operation the equipment, observe precautions (Clause 7.2).
Warning!
Don’ts:

dismantle and/or adjust operational units of the card capture reader;
 clean the card capture reader with substances that may cause damage or
corrosion;

keep the card capture reader out of jerking and thrusting.
9.1 Power-up
1. Switch on the ACS-controller in accordance with its service documentation.
2. Connect power supply unit to the mains with voltage and frequency given in its
Certificate. Switch on the power supply unit.
3. The white indicator “Insert the card into the slot” and LED backlight of the slot will
switch on the indication module.
4. Check operation of the card capture reader together with the ACS-controller in all
modes according to the operation algorithm (see Clause 9.2).
Note:
The operation of the card capture reader is only possible after the configuration of
the ACS-controller. The configuration procedure is described in the service
documentation for the controller and ACS software, the card capture reader
operation algorithm – see sect. 5.4. Configuration in the system PERCo – see
Appendix 1. and Appendix 2.
9.2 Presenting an access card
The access card is presented by inserting it into the slot (5) of the cover (2) in card capture
reader.
9.2.1 Temporary guest card
If visitor's card is valid (i.e. meets all access criteria) and should be withdrawn, then LED
indication of the slot will switch to flash mode, the shutter will open mechanism of card
capture reader and the card will fall into the container.