PERCo IC-05, Руководство по сборке и эксплуатации

Страница: 15 / 34

Assembly and Operation Manual
14
3. Mount the card capture reader power supply according to instructions in its operation
documentation.
4. Prepare the underfloor raceway matching the feed-through hole in the card capture
reader housing, in case it is needed and lay the cables in it.
5. Set the anchors all the way down the prepared holes.
6. Remove the container (3) of the card capture reader in the order described in
section 9.4.
7. Place the card capture reader on the mounting surface so that the four holes in the
base are aligned with the holes on the mounting surface. Pre-route the cables inside
the card capture reader through a hole in its base. Fasten the card capture reader by
using anchor bolts and controlling its position vertical position with a level.
Note:
There is a removable base designed for easy mounting of the card capture reader.
The housing of the card capture reader is fixed on the base with eight screws (you
can reach them in the lower part within the housing).
8. Remove the cover of the card capture reader (2). To do this, unscrew the two set
screws (10) and lift the cover up by holding the front edge. Be careful, do not damage
the cable of the indication module that is installed in the cover! Disconnect the cable
from the indication module and take off the cover.
9. Mount the card reader ( purchased separately) on a special bracket under the cover
of the card capture reader to provide reading of the access card that are inserted
in the slot of the card capture reader mechanism.
Attention!
Built-in reader should be purchased separately.
Inside the card capture reader, it is possible to mount all PERCo readers. It is also
possible to mount the readers by third-party manufacturers if they comply to the
following technical requirements:
- dimensions (length - width - height)
..................... not more than 140×50×28 mm
- reading range of identifiers .................................................. not less than 40 mm
Drill the holes for screws in the bracket plate in order to fix the reader or use the
mounting tape. It is possible to adjust the bracket, therefore, you can change the
distance between the reader and the slot so the ID card is readable.
10. Route the cables up the back wall, lead them to the control board of the card capture
reader and to the reader and connect them according to the wiring diagram (Fig. 6,
Fig. 8). Secure all cables inside the card capture reader housing by using the cable
ties and self-adhesive plates included in the delivery set, ensure that it is possible to
remove the container freely.
11. Check the proper routing and integrity of all cables. Subsequently, check the
correctness and reliability of the electrical connections of the card capture reader with
the PS and the ACS-controller.
12. Mount the cover (2) in the working position after connecting the indication module
cable.
13. Install container (3) in the working position, by closing the lock with key (4).