PERCo IC-05, Руководство по сборке и эксплуатации

Страница: 8 / 34

IC-05 Card Capture Reader
7
5.2 Design
The design of the card capture reader is shown in Figure 2. Numbers of the items
hereinafter refer to the item numbers as shown in Figure 2.
The
housing of the card capture reader (1) is fixed on the base (6) with the screws. The
front side of the housing holds the container for receiving cards (3) and has a lock (4).
Removal of the container provides the access to screws (10) that secure the
cover
of the
card capture reader to the control board (located on the rear panel).
The cover of the card capture reader is fixed on the housing with two screws (10).
Indication module
with three mnemonic indicators is integrated into the cover of the card
capture reader (2) (see Fig. 3). During installation, you must choose which of the two
green indicators will be used to permit the passage (depends on the side where the card
capture reader is installed) 1 .
– Green indicator “Permission of passage”
– White indicator “Insert the card into the slot for cards capturing”
– Green indicator “Permission of passage”
Figure 3. Mnemonic indicators display unit
As well as the cover has a slot (5) for guest cards capturing.
Control board view is shown on Figure 4. The board has terminal blocks:
XT1
–
“Capture card”
input of the card capture reader (
INPUT
and
GND
contacts)
.
Withdrawal of a card that is inserted in the slot is performed when the control signal is
sent from the output of the ACS-controller to the input.
XT2
–
“Card captured”
outputs of the card capture reader (
OUT
and
COM
contacts) and
“Alarm”
(
Alarm
and
COM
contacts). The
“Card captured”
control signal is sent by the card
capture reader to the input of the ACS-controller after withdrawal of the card and
confirms the permission of passage. The
“Alarm”
control signal is generated by the card
capture reader at fault, malfunction, or when the container is filled with cards.
XT4
–
“LED”
indication control inputs that permit the passage of the card capture reader
.
When the signal is sent to the selected input of card capture reader (contact
L
for left or
contact
R
for right indicator) from the output of the ACS-controller, the corresponding
indicator of passage permission will light up on the indication module of the card capture
reader.
XT5
– connector with
RS-485
interface for wiring from the ACS-controller (terminals
A
and
B
).
XT6
– connector for connection of the PS of the card capture reader (contacts
+12V
and
GND
).
XT8
– connector for connection of the reader of the card capture reader to the lines with
RS-485
interface (terminals
A
and
B
).
1
It's allowed to use both green indicators simultaneously to permit passage.