PERCo IC-05, Руководство по сборке и эксплуатации

Страница: 20 / 34

IC-05 Card Capture Reader
19
After withdrawal of the card, the indication of the slot will switch to the initial constant light
mode, the green arrow will light up on the indication module – the passage permission
indication, OD will unblock in the direction of the passage.
If the card is not valid, then the LED backlight of the slot will not switch to a flashing mode
and the passage will not be unblocked.
If a valid card for some reason has not been withdrawn by the card capture reader (for
example, a visitor didn't let it fall down in the slot after the presentation), then the passage
through the OD is denied, the card capture reader will switch to the initial state before the
next presentation of a valid card
.
9.2.2 Permanent card of staff
Employee should present a permanent card by inserting it in the slot (5) located in the
cover of the card capture reader (2).
If the card is valid, then the permission of the passage indication will light up on the
module of the card capture reader, the shutter mechanism of the slot will remain closed,
the card will not be withdrawn. OD will unblock.
If the card is not valid, then the indication of the card capture reader will remain in its initial
state, the passageway will not be unblocked
.
9.3 Blocking of card capturing when filling the card container
When the container of the card capture reader is filled with withdrawn access cards, the
backlight of the slot will switch to a flashing mode: 2 seconds on / 2 seconds off. This
warning signal informs technicians that the container must be emptied from cards. If the
container is not empty, then withdrawal of the access cards will be blocked after the card
capture reader receives another 9 cards.
When the container is full, the card capture reader generates an
"Alarm"
signal, which can
be used by the ACS-controller for further system response to this signal (e.g., switching on
the alarm).
To resume capturing of guest cards it is necessary to extract the full container from the
card capture reader and empty the cards (the order of the container extraction and
installation is described in Clause 9.4.
Note:
While the capturing of guest cards is blocked the permanent cards are operated in
normal order.
If the container is free from cards but the card capture reader is still blocked a likely reason
for this could be failure of the card capture reader units. It is recommended to apply to the
PERCo Technical Support Department.
9.4 Removal and installation of the card container
To take out the card container (3) from the card capture reader proceed as follows:
1 Insert the key into the card container lock (4).
2 Turn the key all the way (open the lock).
3 Pull the container toward you.
4 Lightly lift the card container and take it out.
To insert the card container into the card capture reader, proceed as follows: