Assembly and Operation Manual
22
8. Switch to
"Additional inputs"
tab.
9. If the card capture reader acts as an external verification device for the controller
(“Card captured” signal is sent to a separate input of the controller), then select
"Additional input №…"
(number of the input of the controller that is physically
connected to the
“Card captured”
output of the card capture reader) and set the
following parameters by using the drop-down menu:
set
"Confirmation from external verification device"
value
for the
"Type"
parameter;
set
"Disconnected"
value
for the
"Normal state of the contact"
parameter;
set
"Device
… direction …"
value for the
"Device number"
parameter (the
number of OD and direction number must match those that are controlled by the
card capture reader):
10. If necessary, configure the system response to the "
Fault"
signal sent by the card
capture reader. To do this: select
"Additional input №..."
(number of the input must
match the input of the controller that is physically connected to the “
Fault”
output of the
card capture reader) and set the following parameters by using the drop-down menu:
set
"Standard"
value for
"Type"
parameter,
set
"Disconnected"
value
for the
"Normal condition of the contact"
parameter:
Содержание IC-05
Страница 1: ...Card Capture Reader IC 05 ASSEMBLY AND OPERATION MANUAL ...
Страница 2: ...Card Capture Reader IC 05 Assembly and Operation Manual ...
Страница 34: ...www perco com ...
