PERCo IC-05, Руководство по сборке и эксплуатации

Страница: 13 / 34

Assembly and Operation Manual
12
8 INSTALLATION INSTRUCTIONS
Attention!
The manufacturer will not accept liability for any damage to the card capture reader
or otherwise loss caused as a result of improper installation, and will dismiss any
claims by the customer should the installation work be carried out not in accordance
with this Manual.
8.1 General recommendations
When installing the equipment, observe precautions (see Clause 7.1).
Installation to be carried out by at least two persons qualified to perform assembly and
electric works.
Proper installation is critical to performance and serviceability of the card capture reader.
We strongly advise to study this section before installation work, and follow the instructions
to the latter.
The card capture reader should be placed in front of the OD at the exit from the enterprise.
It is necessary to enable access to the container for operating personnel.
We recommend:
 mount the card capture reader on flat, solid concrete floors (grade 400 or higher,
SCS B22.5), stone or similar foundations at least 150 mm thick;

use reinforcing elements 300×300×150 mm for installation on less steady
foundations;
 make sure the mounting foundation is horizontal and flat; the flatness deviation
must not exceed 1,5 mm;

use
“SORMAT”
anchor bolts to fix the card capture reader.
8.2 Installation tools
We advise to use the following tools for the installation work:

hammer drill 1.2

1.5 kW;

Ø
16 mm,
Ø
30 mm hard-alloyed drill bits;

cross-head screwdriver No. 2 (150 mm);

knife;
 measuring tape (1 m);
 level gauge.
Note:
Other tools can be used that don’t deteriorate the quality of installation work.