PERCo IC-05, Руководство по сборке и эксплуатации

Страница: 11 / 34

Assembly and Operation Manual
10
3. Withdrawal of the card.
The second optical sensor registers the fact of withdrawal when you drop the card into the
container. In this case, the
"Card captured "
control signal is sent from the output of the
Control board of the card capture reader to the ACS-controller and serves as a
confirmation of the withdrawal of the card and activates the passage permission. Upon
receiving the signal, the ACS-controller permits the passage in a specified direction and
deactivates the
"Capture card"
signal from the input of the control board of the card
capture reader. The LED backlight of the slot will switch from flashing mode to the
constant indication mode.
4. Permission of the passage indication.
Control of indication for passage permission is carried out irrespectively from the operation
of the card capture reader mechanism. After the card has been withdrawn,
the ACS-controller sends the control signal that permits the passage through the OD (e.g., a
turnstile) and simultaneously sends the control signal that controls the indication to the
board of the card capture reader. The arrow with the corresponding direction will light up on
the cover of the display unit (depending on the selected input of the card capture reader:
contact
L
is for the left arrow, the contact
R
is for the right, it is also possible to send a signal
simultaneously to both inputs).
5. Indication that informs about the full container and malfunction of the card
capture reader.
The container is filling as the cards are withdrawn. The third optical sensor activates and
LED backlight of the slot and switches to flash mode when the container is filled: 2
seconds on / 2 seconds off indication warns the operator that it is necessary to empty
container from cards. The
"Alarm"
control signal is formed at the output of the card capture
reader control board, which can be used to indicate the overfill of the container.
The card capture reader operation will be blocked after it receives another 9 cards if the
container is not emptied. Unblocking of the card capture reader and deactivation of the
"Alarm"
signal will occur automatically when the container is emptied from cards (see
sect. 9.4).
If the container is emptied from cards, but the
"Alarm"
signal from the output of the card
capture reader control board is not deactivated, then there might be a malfunction of the
card capture reader. In this case, it is recommended to contact your nearest
PERCo
service center. The list of
PERCo
service centers is given in the datasheet.
5.5 The use of the card capture reader in a third-party ACS (with
Wiegand interface)
When you use a card capture reader in a third-party ACS, the data exchange between the
reader of the card capture reader and the ACS-controller is performed via
Wiegand
interface (the type of interface depends on the equipment that is used in the ACS). In this
case, it is necessary to connect the reader of the card capture reader to the ACS-controller
directly, i.e. bypassing the Control board of the card capture reader. It is possible to power
the reader with 12VDC by connecting it to the
XT9
connector of the card capture reader
board.