Paul CLIMOS F 200, Оригинальная инструкция по эксплуатации

Страница: 35 / 68

35
Connection of several TFT touch panels 3.4.3
It is possible to connect up to three TFT touch panels as control units for the ventilation device. On the
hardware side, the TFT touch panels shall be connected in parallel to the terminal X1 of the adapter
board according to conductor assignment
Tab. 20 . The TFT touch panels shall be successively
commissioned and re-addressed (factory setting default address = 1). Addressing of the TFT touch
panels is performed at software level in the setup/submenu Several control panels.
Symbol Designation Explanation / actions
Address two TFT control panels Connect the first TFT touch panel
Button
Menu mode By touching the button Menu mode, you reach the main menus.
Buttons
Navigation By touching the navigation buttons, select the main menu setup
and confirm with Enter.
Button
Password Password prompt
Enter the password _ _ _ _ _ and confirm with Enter.
Buttons
Navigation By touching the navigation buttons, select the submenu Several
control panels and confirm with Enter.
Buttons
Navigation By touching the navigation buttons, select the address number 2
and confirm with Enter.
Connect the second TFT touch panel
Sequence of steps for software addressing not applicable since
address number = 1 (factory setting)
Address three TFT control panels Connect second TFT touch panel
Perform the sequence of steps for software addressing as before,
assign address number 3.
Connect third TFT touch panel
Sequence of steps for software addressing not applicable since
address number = 1 (factory setting)
Tab. 21: Sequence of steps connection / addressing of several TFT control panels
The connection of several control panels with the same address number results in a
communication error!
The operation mode of the ventilation device is based on the last input instruction at one
of the TFT touch panels connected.
Connection of the LED control panel 3.4.4
The operation of the ventilation device is only possible with one a control unit type LED control panel. The
cable of the type J-Y(ST)Y 2x2x0.6 must be connected to the terminal X1 or the adapter board in
accordance with
Tab. 20 . The ribbon cable connects the adapter board with the board of the LED key-
pad.