Paul CLIMOS F 200, Оригинальная инструкция по эксплуатации

Страница: 33 / 68

33
Electrical connections 3.4
Electrical connections must be established in accordance with the applied standards to
electrical equipment and only by qualified personnel!
The electrical power supply of the CLIMOS is provided via the 3-pole plug connection A of a lower power
device by means of the power cable. The CAT5 network cable is connected to the RJ45 B jack. Both plug
connections are located on the side of the casing on which the type plate is applied. Analogue and digital
input / output signals of sensors (e.g. indoor air quality sensors) or actuators (e.g. boost ventilation
switch) are connected to the respective terminal points of the master controller. The cable bushings pre-
cut
C in the casing panel must be broken out as needed and the cables of the sensors / actuators must
be guided through cable glands M16.
Fig 25: Casing side of the electrical connections
Position Designation
A 3-pole IEC connector
B RJ45 jack
C Pre-cut cable bushing (2x) for cable gland M16
3.9.5 Circuit diagram CLIMOS Basic series
3.9.6 Circuit diagram CLIMOS Comfort series
3.9.7 Terminal scheme master controller
Tab. 19: Assignment of the electrical connections
The RJ45 jacks are exclusively serve the components of the internal RS485-BUS! Any
other usage results in the damage of the control modules!
Connection of the adapter board 3.4.1
The adapter board with the 2-fold RJ45 plug connection and the 5-pole screw terminal X1 is used for
communication of the modules via the internal RS485-BUS. The CAT5 network cable establishes the
internal connection between the RJ45 jack of the CLIMOS and one of the two RJ45 jack of the adapter
board.
Fig 26: Adapter board
Fig 27: Casing for adapter board
C
B
A
X1