Paul CLIMOS F 200, Оригинальная инструкция по эксплуатации

Страница: 26 / 68

26
7. Close all filter covers in reverse order.
8. Proceed in the same manner for the other device filter.
9. Re-establish the mains connection.
Resetting the filter run-time 2.4.2
Once the filter has been changed, the counter for the filter run-time must be reset. Resetting the filter run-
time can be performed using the respectively connected control unit or the digital input signal
(programmable with PC software as special solution).
2.4.2.1 Resetting the filter run-time by means of the LED control panel
Symbol Designation Explanation / actions
LED 10
Signalling
Filter run-time When the LED 10 lights up, the filter run-time has expired and a filter
check shall be performed.
Key
Reset
Filter run-time By pressing this key for at least 3 s, the filter run-time is reset. The
LED 10 goes off. The timer starts the set filter run-time.
Tab. 17: Resetting the filter run-time by means of the LED control panel
2.4.2.2 Resetting the filter run-time by means of the TFT touch panel
Symbol Designation Explanation / actions
Signalling
Filter run-time
expired In case the filter run-time has expired, the message “Replace filter”
is generated, signalling that the filter must be checked.
Button
Menu mode By touching the button Menu mode, you reach the main menus
Buttons
Navigation Select the main menu Settings by touching the Navigation buttons
and confirm by pressing the Enter button.
Buttons
Navigation Select the submenu Filter by touching the Navigation buttons and
confirm by pressing the Enter button.
Button
Checkmark By touching the Checkmark button, resetting of the filter run-time
is selected.
Button
Enter Confirm by pressing the Enter button.
Button
Cancel / back By touching the Cancel / back button, exit the menu levels until the
start menu appears.
Tab. 18: Step sequence resetting the filter run-time by means of the TFT touch panel
All maintenance work performed must be documented in check list A!