24
Replacement of the filter
2.4.1
The plant must not be operated without filter. During filter replacement and maintenance
work, the ventilation device must be switched off!
Two high-quality original filters of the manufacturer are installed inside the CLIMOS. After the
corresponding message of the control panel or after visualisation of a programmed digital output signal,
the filters in the CLIMOS shall be checked. In order to do so, proceed as follows:
1. Switch the device to standby mode or disconnect it from the power supply.
2. If applicable, pull the red design filter cover
A
out of the casing cover’s holder.
3. Grasp into the recessed grip
B
of the filter compartment.
Perhaps the EPP-filter covers are very tight during the first filter change. Using a
blunt object (e.g., the handle of a spoon) the EPP-filter cover can be levered.
Fig 11: Recessed grip filter compartment
A
B
Fig 10: : Removal of the design filter cover
A
Содержание CLIMOS F 200
