VoIP profile configuration task list
571
SmartWare Software Configuration Guide
47 • VoIP profile configuration
Configure codecs
The VoIP profile contains a
list
of codecs the forms the set of allowed codecs that can be used to set up a VoIP
connection. The list is assembled in order of priority (i.e. the first entered codec is the most preferred one). For
each codec in the list, a set of parameters can be configured.
Procedure:
Add a codec to the list (this procedure is valid for all other codecs as well).
Note
If you press the
<tab>
key after entering a few letters of a configuration com-
mand, the full command name will display or a listing of commands that
begin with those letters will display. Press the
<enter>
key to select the
desired command.
Signaling protocols have a codec negotiation mechanism, it is not
guaranteed that the first codec in the list is used to set up the con-
nection. Each codec in the list may be used. To make sure that
only one codec is possible, configure this codec alone. See how
to display the currently configured codecs in a VoIP profile on
page 584
.
The default VoIP profile contains the codecs G.711uLaw and
G.711aLaw. If you don’t want to use these, you must explicitly
remove them from the list.
IMPORTANT
IMPORTANT
Содержание SmartNode Series
