PPP Dial-up over ISDN
336
SmartWare Software Configuration Guide
30 • PPP configuration
Dial-up on monitor
Dial when a monitored interface is reported down and drop when that interface is reported up again. A delay
time prevents to dial or drop if the monitored interface changes the state only for a short time.
Mode:
context ip/interface
Dial-up nailed
Dial if possible, and never drop.
Mode:
context ip/interface
Step
Command
Purpose
1
[
name
] (if-ip) [
interface
]#[no] dial-up mon-
itor interface <ip-interface> [dial delay
<seconds>] [drop delay <seconds>]
[queue-limit <number>]
Configure dial-up to monitor the interface
specified. Dial delay specifies the timeout
before dialing (Default 10). Drop delay speci-
fies the timeout before dropping connection
(Default 10). Queue-limit specifies the max.
number of packets to queue while the link is
down (Default 4).
Step
Command
Purpose
1
[
name
] (if-ip) [
interface
]#[no] dial-up
nailed [queue-limit <number>]
Configure dial-up nailed. Queue-limit speci-
fies the max. number of packets to queue
while the link is down (Default 4).
Содержание SmartNode Series
