RIP configuration task list
244
SmartWare Software Configuration Guide
23 • RIP configuration
Specifying the receive RIP version
By default, RIP version 1 and version 2 packets are received. Alternatively, you can explicitly configure the RIP
version to be received with the last command argument as following:
•
1
—to receive RIP version 1 packets
•
1or2
—to receive RIP version 1 and version 2 packets
•
2
—to receive RIP version 2 packets
This procedure describes how to set receiving RIP version on an interface
Mode:
Interface
Example:
Specifying the receive RIP
The following example shows how to select receive RIP version
1or2
on IP interface
wan
.
node(cfg)#context ip router
node(ctx-ip)[router]#interface wan
node(if-ip)[wan]#rip receive version 1or2
Enabling RIP learning
A new route is added to the local routing table, if the routing update contains a route to a destination that does
not already exist. If the update describes a route whose destination is already in the local table, the new route is
used only if it has a lower cost. The cost of a route is determined by adding the cost of reaching the gateway
that sent the update to the metric contained in the RIP update packet. If the total metric is less than the metric
of the current route, the new route is used. Two RIP learning mechanisms are offered, which are represented by
a specific argument of the command
rip learn
:
•
host
—for RIP learn host and
•
default
—for RIP learn default
See the following sections on how to configure those two RIP learning mechanisms.
This procedure describes how to enable accepting of IP host and default routes received on an interface for
RIP learning
Mode:
Interface
Example:
Enabling RIP learn host and default
Step
Command
Purpose
1
node
(if-ip)[
name
]# rip receive version {1 | 1or2 | 2}
Selects receive RIP version for interface
name
Step
Command
Purpose
1
node
(if-ip)[
name
]# rip learn host
Enables accepting of IP host routes received on interface
name
2
node
(if-ip)[
name
]#rip learn default
Enables learning using a default route advertised by an RIP
neighbor on interface
name
Содержание SmartNode Series
