Call router configuration task list
500
SmartWare Software Configuration Guide
40 • Call router configuration
Example:
Create a hunt group service
This example shows how to configure the hunt group service as shown in
figure 66
on page 493.
node(cfg)#context cs
node(ctx-cs)[switch]#service hunt-group HUNT-BRI
node(func)[HUNT-BRI]#cyclic
node(func)[HUNT-BRI]#timeout 6
node(func)[HUNT-BRI]#route dest-interface IF-BRI0
node(func)[HUNT-BRI]#route dest-interface IF-BRI1
node(func)[HUNT-BRI]#route dest-interface IF-BRI2
node(func)[HUNT-BRI]#route dest-interface IF-BRI3
Protocol Error
(Cont.)
ie-does-not-exist
Drop original call
The remote equipment receives a message
that includes information elements or call
properties that are not recognized.
invalid-ie-contents
Drop original call
The remote equipment receives a message
that includes invalid information in the
information element or call property.
recovery-on-timer-
expiry
Drop original call
Your call was not completed, probably
because an error occurred.
protocol-error
Drop original call
An unspecified protocol error with no
other standard cause occurred.
Interworking
interworking
Drop original call
An event occurs, but the network does not
provide causes for the action it takes. The
precise problem is unknown.
Table 21. Hunt group drop causes (Continued)
Class
Cause
Default Behavior
of the Hunt
Group Service
Description
Содержание SmartNode Series
