FXO interface configuration task list
419
SmartWare Software Configuration Guide
36 • FXO interface configuration
Configuring the destination of the call
The last command in configuring the FXO Interface is the route command. This command configures the call
router. You can configure the routing-destination for call setup and for service activation. For complete details,
see chapter 40,
“Call router configuration”
on page 451.
Mode:
Interface FXO
FXO Mute dialing
A new command has been added. With this command, the FXO interface can mute its receive path during
dialtone detection and DTMF digits sending. This to avoid unwanted noises on the calling side (for calls going
out of the device through FXO).
Mode:
interface fxo
Step
Prompt, command & response
Purpose
1
node>
Basic prompt in Operator Exec mode
2
node>enable
Enters Administration execution mode
node#
Response: The prompt in administra-
tion execution mode is the #
3
node#configure
Enters the Configure configuration
mode
node(cfg)#
Response: The prompt in the Configure
configuration mode is (cfg)#
4
node(cfg)#context cs
Enters the Context CS configure mode
node(ctx-cs)[switch]#
Response: The prompt in the Context
CS configuration mode is (ctx-
cs)[switch]#
5
node(ctx-cs)[switch]#interface fxo
if-name
Enter the Interface FXO configuration
mode
node(if-fxo)
[if-name]
#
Response: The prompt in the Interface
FXO configuration mode is (if-fxo)
[if-name]
#
6
node(if-fxo)
[if-name]
#[no]
route {call {dest-interface
interface-name
| dest-service
table-name
| dest-table
service-name
} | precall {dest-interface
interface-name
|
dest-service
table-name
| dest-table
service-name
}
Use this command to route a call (dest-
interface) directly to an interface speci-
fied with the
interface-name
parame-
ter, (dest-table) to the call router using
the
table-name
table as the first routing
table, or (dest-table) directly to a ser-
vice specified with the
service-name
parameter.
Step
Command
Purpose
1
[
name
] (if-fxo)# [no] mute-dialing
Enables or disables mute of receive path during dialtone
detection and dialing. Default:
Disabled
.
Содержание SmartNode Series
