![background image](http://html1.mh-extra.com/html/patton-electronics/smartnode-series/smartnode-series_software-configuration-manual_4048643284.webp)
SNTP client configuration task list
284
SmartWare Software Configuration Guide
26 • SNTP client configuration
Enabling and disabling the SNTP client
The SNTP client is disabled by default and has to be enabled if clock synchronization shall be used. This pro-
cedure describes how to enable or disable the SNTP client
Mode:
Configure
Example:
Enabling the SNTP client operation
node(cfg)#sntp-client
Example:
Disabling the SNTP client operation
node(cfg)#no sntp-client
Defining SNTP client poll interval
Specifies the seconds between each SNTP client request in unicast or anycast mode.
This SNTP client poll interval can be defined to be within the range from 1 to 4’294’967’295. The default
value is 60 seconds.
This procedure describes how to set the SNTP client poll interval
Mode:
Configure
Example:
Setting the SNTP client poll interval
In the following example the SNTP client poll interval is set to 30 seconds.
node(cfg)#sntp-client poll-interval 30
Step
Command
Purpose
1
node
(cfg)#[no] sntp-client
Enables the SNTP client operation. Using the no command syntax dis-
ables this feature.
Step
Command
Purpose
1
node
(cfg)#sntp-client poll-interval
value
Sets the SNTP client poll interval to value seconds
Содержание SmartNode Series
