PRI port configuration task list
198
SmartWare Software Configuration Guide
16 • PRI port configuration
Configuring HDLC Encapsulation
The hdlc encapsulation command specifies what kinds of upper layer data are contained in the hdlc frames.
Two encapsulation types are available, framerelay and ppp. For more details see Chapter 15,
“Frame Relay con-
figuration”
on page 175 and Chapter
30,
“PPP configuration”
on page 311
.
Mode:
hdlc
PRI Debugging
For the investigation of possible problems in link establishment, data transmission or synchronization, there
exists a debug command with the options ‘event’ and ‘error’. The command has a hierarchical characteristic
and can be applied to all ports of given type on the whole device, or to all ports of slot or just to one specific
port.
Step
Command
Purpose
1
[
name
] (hdlc)#encapsulation {framere-
lay | ppp}
Specifies the encapsulation type of hdlc.
Default:
no encapsulation
Содержание SmartNode Series
