40
DEMOQE128 User Manual
8.4.1
J11 - P&E’s Logic Analyzer Inputs IN0/IN1
The logic analyzer inputs are marked on one side of the J11 jumper. The
inputs allow P&E’s PC-based logic analyzer application to display these
signals in real-time.
By installing both jumpers, the logic analyzer pins IN0 and IN1 will be
connected to PTC0 and PTC1 respectively.
By removing these jumpers IN0 and IN1 will be unconnected. The
user may connect these signals, via wires, to any other signals on the
processor which they wish to view on the PC.
Figure 8-8: Jumper Settings for Input Signals to P&E’s Embedded Multilink, P&E
INPUT_EN (J11)
8.4.2
J12 - Light Touch Switch Enable Jumper KEY_ENABLE
Enables the corresponding switch. Each jumper may be individually
installed or removed. By default, all jumpers are installed to enable all
the switches.
Figure 8-9: Jumper Settings for Light Touch Switches KEY_ENABLE (J12)
8.4.3
J18 - Reset Switch Enable and Reset LED Display Enable Jumper
RESET_EN
Enables the Reset Switch and the Reset LED Display. Each jumper
