DEMOQE128 User Manual
13
Figure 3-6: MCU Change Wizard
7.
Click “Finish.” In the background CodeWarrior will transform your
project to the 32-bit microcontroller with no software changes needed.
An informational “Project Messages” window may appear letting you
know that changes have been made to the project.
8.
If the Logic Analyzer utility is open, click the “Close Port” button on
that utility.
9.
Turn the board power switch to OFF.
10.
Switch the green 8-bit S08 daughter card with the red 32-bit Cold-
Fire V1 daughter card. Make sure to align pin 1 (as marked by
arrows) on the daughter card with pin 1 on the board.
11.
Turn the board power switch to ON.
12.
Compile the transformed Quick Start Application and start the pro-
cess of programming it into the flash on the 32-bit QE128 microcon-
troller by clicking on the debugger launch button shown here :
Figure 3-7: IDE Debugger Launch Button
13.
From the Connection Manager menu, select “USB1: DEMOQE”
port and click on “Connect (Reset).”
14.
From the Loader Warning menu, click on “OK” to allow the debug-
ger to mass erase the microcontroller’s on-chip flash memory and
program it with the new application.
15.
Click on the GO button in the debugger to run the application. The
GO button is shown here:
Figure 3-8: Debugger GO Button
16.
Repeat Step 4 of the Quick Start Guide instructions to observe the
32-bit QE128 device running the same application as the 8-bit
QE128 device did previously.
