DEMOQE128 User Manual
17
8.
Click the button labeled PTA3 on the board to enable data averaging,
and move the board.
9.
Click the button labeled PTA2 on the board to enable data filtering,
and move the board.
Change device to 32-bit ColdFire V1:
1.
Click “Close Port” in the Accelerometer Demo utility.
2.
Close the “True-Time Simulator & Real-Time Debugger” window.
3.
Bring the CodeWarrior IDE window to the front with the Accelerome-
ter Application project for the 8-bit microcontroller.
4.
Open the MCU Change Wizard to switch the project to the 32-bit
microcontroller by clicking on the following button in the project panel:
5.
From the wizard, change the microcontroller selection from the 8-bit
“MC9S08QE128” to the 32-bit “MCF51QE128” in the Flexis>QE Fam-
ily tree.
6.
Click “Finish.” In the background CodeWarrior will transform your
project to the 32-bit microcontroller with no software changes needed.
7.
Turn board power switch to OFF.
8.
Switch the green 8-bit S08 daughter card with the red 32-bit ColdFire
V1 daughter card. Make sure to align pin 1 (as marked by arrows) on
daughter card and with pin 1 on the board.
9.
Turn board power switch to ON.
Run demo on 32-bit ColdFire V1:
1.
Compile the Accelerometer Application and start the process of pro-
gramming it into the flash of the 32-bit QE128 microcontroller by click-
ing on the debugger launch button shown here :
2.
From the Connection Manager menu, select the “USB1: DEMOQE”
