Panasonic PT-REQ12 Series, Руководство по эксплуатации, Страница: 175 / 306

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 175
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DEFAULT]
Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (
x
page 281)
[USER] Changes the setting of the <REMOTE 2 IN> terminal.
f
Proceed to Step 3) when [USER] is selected.
3) Press the <ENTER> button.
4) Press
as
to select one from [PIN2] to [PIN8], and press
qw
to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press
as
to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f
The [FUNCTION BUTTON] screen is displayed.
3) Press
as
to select a function.
[DISABLE] Disables the <FUNCTION> button.
[SUB MEMORY]
Displays the sub memory list. (
x
page 191)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f
When the input is SDI
g
The [DISPLAY OPTION] menu → [SLOT IN] → [SYSTEM SELECTOR]
f
When the input is anything other than SDI
The [PICTURE] menu
→ [SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (
x
page 99)
[FREEZE] Temporarily pauses the image. (
x
page 143)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (
x
page 143)
[LENS MEMORY LOAD]
Loads the registered lens memory. (
x
page 147)
[ASPECT] Switch the aspect ratio of the image. (
x
page 105)
[PROJECTION METHOD] Switches the [PROJECTION METHOD] setting. (
x
page 145)
[GEOMETRY]
Switches the [GEOMETRY] setting. (
x
page 107)
[ANGLE MONITOR]
Displays the [ANGLE MONITOR] screen. (
x
page 179)
4) Press the <ENTER> button.
Note
f
The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
[STATUS]
Display the status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The [STATUS] screen is displayed.
3) Press
qw
to switch the pages.
f
The page will change each time you press the button.
[PROJECTOR TYPE] Displays the type of the projector.
[SERIAL NUMBER] Displays the serial number of the projector.
[PROJECTOR RUNTIME] Displays the runtime of the projector.
[LIGHT RUNTIME] Displays the runtime of the light source 1 and the light source 2.
[CONTINUOUS LIGHTING
TIME]
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.