Panasonic PT-REQ12 Series, Руководство по эксплуатации

Страница: 161 / 306

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 161
2) Press the <ENTER> button.
f
The [BRIGHTNESS CONTROL] screen is displayed.
3) Press
as
to select [REGULAR CALIBRATION].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Does not measure the brightness and color of the light source periodically.
[ON]
Measures the brightness and color of the light source by the brightness sensor at the time specified
by [CALIBRATION TIME].
f
Proceed to Step 5) when [ON] is selected.
5) Press
as
to select [CALIBRATION TIME].
6) Press the <ENTER> button.
f
The projector is in the adjustment mode (the time is blinking).
7) Press
qw
to select “hour” or “minute”, and press
as
or the number (<0> - <9>) buttons to set a
time.
f
Selecting “hour” allows setting of only the hour in increments of one hour, and selecting “minute” allows
setting of only the minute in increments of one minute between 00 and 59.
8) Press the <ENTER> button.
f
[CALIBRATION TIME] is set.
Note
f
The [REGULAR CALIBRATION] setting will be reflected at the time when the item is switched using
qw
.
f
The [CALIBRATION TIME] setting will be reflected at the time when you enter the time and then press the <ENTER> button.
f
The [REGULAR CALIBRATION] setting item is common with the following menu item.
g
The [PROJECTOR SETUP] menu
→
[BRIGHTNESS CONTROL]
→
[BRIGHTNESS CONTROL SETUP]
→
[REGULAR CALIBRATION]
f
The [CALIBRATION TIME] setting item is common with the following menu item.
g
The [PROJECTOR SETUP] menu
→
[BRIGHTNESS CONTROL]
→
[BRIGHTNESS CONTROL SETUP]
→
[CALIBRATION TIME]
Setting [CALIBRATION MESSAGE]
Set whether to display the time to complete the measurement while the brightness and color of the light source
are measured.
1) Press
as
to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f
The [BRIGHTNESS CONTROL] screen is displayed.
3) Press
as
to select [CALIBRATION MESSAGE].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON]
Displays the time to complete the measurement while the brightness and color of the light source are
measured by the brightness sensor.
[OFF]
Does not display a message during the measurement.
Note
f
The [CALIBRATION MESSAGE] setting will be reflected at the time when the item is switched using
qw
.
f
The [CALIBRATION MESSAGE] setting item is common with the following menu item.
g
The [PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [CALIBRATION MESSAGE]
Brightness control adjustment procedure example
The steps exemplify an adjustment to link the brightness and white balance of eight projectors connected in a
network.
1) Connect all projectors to a switching hub using LAN cables. (
x
page 209)
2) Switch on all projectors and start projection.