Panasonic LP-M Series, Руководство по обслуживанию

Страница: 165 / 174

165
ERROR
CODE
Error description Measures
E605
Exceed valid number of characters.
(Max. 30 characters/line.)
Make numbers of characters smaller.
E606 Existed marking data outside of marking area.
Contain marking data within marking area.
• Change marking position.
• Make characters smaller.
• Narrow character interval.
* If there is no data out of the marking area in the
image display, check the “system offset” in the
environment setting.
“System offset” value is not shown in the image
display.
E607 Existed invalid character for bolding with setting font.
• Set any standard font without original 4 font.
• Use Font Maker provided to create the proper
pattern font.
E608
Incorrect bold line width setting or character height/width
ratio.
• Set line width of bold character to half or below
of character height.
• When marking the bold character, set the
comparison ratio between character height and
width become 1/10 to 10.
E610
E612
Lack of marking memory.
• Marking data is too large.
• The line length is too long. (spiral, etc.)
• Reduce numbers of characters and logo data.
• Reduce numbers of step & repeat.
• Reduce numbers of a start point and a end
point of characters or logo data.
• Separate the long segment into short data.
E620
to
E622
Cannot follow line speed of flying object marking.
Shorten marking time with the following methods.
• Speed up scan speed.
• Narrow character interval.
• Make characters smaller.
• Reduce numbers of characters.
• Change setting of curve/edge.
• Reduce numbers of character lines.
• Displace a start point of marking, etc.
Adjust the line speed of the flying object.
Adjust the waiting time of the flying object.
Set the coordinate of the marking data close to
the center of the marking field.
E623
Too narrow marking interval for proportioned flying
object.
Increase setting value of marking spacing.
Shorten marking time with the following methods.
• Speed up scan speed.
• Narrow character interval.
• Make characters smaller.
• Reduce numbers of characters.
• Change setting of curve/edge.
• Reduce numbers of character lines.
• Set smaller value to the one-shot output time,
etc.
ME-LPM-SSM-10