Panasonic LP-M Series, Руководство по обслуживанию

Страница: 100 / 174

100
3-5-2 Marking trigger input
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T1 T1
T2
READY OUT
MARKING OUT
TRIG. IN
WARNING OUT
(Active Low)
Item Period Remarks
T1 10 ms or more Keep the ON status for 10 ms or more.
T2 2 to 510 ms It outputs a warning to notify that an invalid trigger was input when a marking trigger was
input during trigger processing. This is One-shot output. You can turn this warning off by
the settings.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• The marking is started when TRIG. IN is turned to ON while either the delay time or delay distance is 0.
• LP-Mxxx-S type requires the laser gate open / close control for trigger marking. Refer to “Marking operation timing chart
during remote and operating modes” (P.122) for detail.
3-5-3 Equidistant marking (flying object marking)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T2 T2 T2
T3 T3 T3 T3
T1
READY OUT
TRIG. IN
MARKING OUT
MARK END OUT
Item Time Remarks
T1 ― The time when the work travels the distance set in the “trigger ready.”
T2 ― The time when the work travels the distance set by marking interval.
T3 2 to 510 ms One-shot output. Set the output time on the environment setting screen.
There is a small margin of error for the setting value.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• Equidistant marking is performed while TRIG. IN is ON.
• The laser marker stops after marking is completed if TRIG. IN is turned to OFF during marking.
• Equidistant marking is performed after travels the distance that is set in the “trigger ready”.
ME-LPM-SSM-10