Panasonic LP-M Series, Руководство по обслуживанию

Страница: 168 / 174

168
ERROR
CODE
Error description Measures
E902 Cannot create 2D code. Use the condition where 2D code can be created.
E903 No specified 2D code pattern.
Specify 2D pattern code which has been already
registered.
E910 Existed invalid character for converting into bar code. Set the character that can be bar coded.
E911 Cannot create bar code.
Use the condition where a barcode can be
created.
E912
Too small dimension of narrow element/basic module
width for bar code.
Specify the setting value for the width of the
narrow element/basic module larger than that of
the line width of the laser.
E913 No quiet zone in bar code.
Set the proper value for “Quiet/Narrow Ratio”.
With the inversion setting, set always quiet zone.
E914 Too small separate pattern or composite row height.
• Correct the “Separator Height/(W)” or “One Bar
Code H.” settings so that the height is larger
than the “Line Width” in the laser settings.
• If you want to remove the separator, set 0 to
the “Separator Height/(W)”.
E915 Cannot create bar code.
Digit number of characters for EAN/ UPC code or
GS1 DataBar code is incorrect.
Enter the prescribed number of characters
according to the code type.
E916
*1
Cannot mark bar code with sphere or vertical cone.
• With 3D setting of sphere or vertical cone, do
not use the barcode setting.
• Set the work shape other than sphere and
vertical cone.
*1 : Error that may occur for LP-M / LP-Z series only.
*2 : Error that may occur for LP-S series only.
*3 : Error that may occur for LP-M / LP-S series only.
*4 : Error that may occur for LP-Mxxx-S type only.
*5 : Error that may occur for LP-M series only.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• When other error not listed in this section was occurred, restart the laser marker.
• If the symptom persists after restart, contact our sales office.
ME-LPM-SSM-10