Panasonic LP-M Series, Руководство по эксплуатации, Страница: 242 / 308

242
Measurement result window
1
5
6
7
8
2
3
4
Item Description
1 Measurement
Power : Measurement result in Watt.
2 Initial Ratio (of
Laser Power) : The current power percentage relative to initial power.
Reference
• The “Current-to-initial power ratio” field shows the relative value expressed as a percentage of the initial power of the
laser oscillator.
• The value of the “Current-to-initial power ratio” is indicated only when the measurement has been made with the “Laser
power setting” being “100”.
Otherwise, the “Current-to-initial power ratio” field shows “---”.
3 Setting Power : Set the output level [%] of laser power.
4 Laser Rad. Time
(Laser Radiation
Time) : Displays the total time of the laser radiation.
5 MEASURE : Press to measure the laser power.
For details, refer to “Laser power measurement” (P.241).
6 CORRECT : Press to correct the laser power.
Refer to “2-9-3 Lot” (P.122) for details.
7 OPTIMIZE : Press to optimize the laser output power according to the installation condition of the
laser marker. Refer to “Laser Output Optimize” (P.237) for details.
8 CLOSE : Returns to the environment setting screen.
To use this function
• The laser output from the fiber laser oscillator in this system declines over time.
•
After the installation, replacement or moving laser marker, the marking energy measurement results may change.
• In case of LP-Sxxx type, after the fiber unit is removed/attached, or focus is adjusted (Refer to “Safety / Setup /
Maintenance Guide”.), the marking energy measurement results may change.
• Use “Laser Output Optimize” (P.237) function to improves the accuracy of “Laser output measurement/correction” results
after the installation, replacement or moving of laser marker.
• Measurement / correction function is available when laser pumping is completed, and the internal shutter is closed.
• For LP-M5xx-S / M2xx-S type, laser power measurement is available when the laser gate is opened.
• The measurement results might have +/-5% difference with normal temperature (20 to 30 Celsius degree).
• The +/-10% difference might occur under the high/low temperature. Correcting power under normal temperature is
recommended.
ME-LPMSZ-OP-7