Panasonic KX-TD500, Справочное руководство системы

Страница: 831 / 1574

4.00 Programming
Before starting up the basic system data
programming, general feature description must
be read.
For further information about general feature
description, refer to Section 3 “System Features
and Operation”.
Basic system data programming can be done
using VT220 compatibles, dumb terminal and
attendant console.
Basic system data programming cannot be done
using PITS except for the several programmings
which are convenient for self-maintenance.
Station data programming can be done using
PITS and attendant console.
(VT220 and Compatibles user)
Refer to Section 8 “Preparation for Programming
and Maintenance (VT220 and Compatibles)” and
Section 10 “System Programming (VT220 and
Compatibles)”.
(Dumb terminal user)
Refer to Section 9 “Preparation for Programming
and Maintenance (Dumb)” and Section 11
“System Programming (Dumb)”.
(PITS user)
Refer to Section 12 “System Programming
(PITS)” and Section 13 “Station Programming
(PITS)”.
(Attendant console user)
Refer to Section 14 “Station Programming
(ATT)”.
5.00 Test
System’s built-in maintenance capabilities and
the basic diagnostics in fault diagnosis and
corrective maintenance are described in Section
15 “Maintenance (VT220 and Compatibles)” and
Section 16 “Maintenance (Dumb)”.
Self-Test (System-Detected Troubles)
The KX-TD500 system has the capability of the
diagnostic self-test which is automatically
executed at the desired time everyday.
It takes a long time to perform the diagnosis of
the whole devices (TSW card, line cards, ports,
resources etc.). If the system detects a device
which is in use while executing the self-test, the
device will be skipped. Therefore, it is
recommended to execute while no traffic.
(VT220 and Compatibles user)
Refer to Section 15-D “Self-Test (System-
Detected Troubles)” for further information.
(Dumb terminal user)
Refer to Section 16-D “Self-Test (System-
Detected Troubles)” for further information.
Functional test by entering commands
Functional test is done by entering specific test
commands when you install the new device and
so on.
(VT220 and Compatibles user)
Refer to Section 15-F “Functional Test by
Entering Commands” for further information.
(Dumb terminal user)
Refer to Section 16-E “Functional Test by
Entering Commands” for further information.
7-B-9