Panasonic KX-TD500, Справочное руководство системы

Страница: 838 / 1574

Operation
Starting up system administration from a remote
location can be done in the following ways:
• Dial “Remote Directory Number” using Direct
Inward System Access (DISA) feature.
For further information about “Remote Directory
Number,” refer to Section 10-D-1.02 “Operation
(2/3)”.
For further information about DISA feature,
refer to Section 3-D-2.02 “Direct Inward System
Access (DISA)”.
• Program DID feature so that the incoming
telephone number is converted to the “Remote
Directory Number”.
For further information about DID feature, refer
to Section 3-D-2.03 “Direct Inward Dialing (DID)”.
• Assign that a call from a remote-location can
access the Remote Administration feature
automatically using DIL (1:1) feature.
For further information about DIL (1:1) feature,
refer to Section 3-D-2.01 “Direct In Line (DIL)”.
• Remote access by operator transfer
The call from a remote location can be made
on any trunk into the system, and be answered
by the operator.
The call is then placed on hold and the Remote
Directory Number of the system dialed is
received. The operator transfers the call after
receiving the modem answer tone. The caller
at a remote location will then hear the modem
answer tone and can proceed with sign-on.
Refer to Section 4-F-1.05 “Unscreened Call
Transfer to Remote,” for further information.
When the system administrator at a remote
location accesses the system remote
administration feature, the following message
appears on the display of operator's telephone if
display is provided:
1234: RMT Access
After you log in to the system from a remote
location, you can operate the system in the same
way as if you were on-site.
Only one system administration terminal can be
connected to the system at a time.
8-A-2
2.00 System Administration
from a Remote Location
Description
From a remote location, you can execute system
programming, diagnosis and traffic measurements
using a VT220 (100) Compatible Terminal and
Modem.
For details about communication parameters, refer
to Section 10-D-7.00 “Communication Interface”.
Conditions
• RMT card (Modem) must be installed in the
system and register the telephone number of
modem in the System-Operation “Remote
Directory Number” (FDN: three or four digits) for
accessing the remote administration feature.
For the assignment of Remote Directory
Number, refer to Section 10-D-1.02 “Operation
(2/3)”.
• For remote access, a data terminal and modem
are required at a remote location.
• Factory programmed four types of password
from the first to fourth levels for remote operation
are provided. Passwords are originally factory
programmed, but may be changed at any time.
(Refer to Section 8-E “Changing Password”.)
• You can execute remote system administration
during on-line communication mode only. But
when you load the system programming data
from a remote location, the system shifts to off-
line communication mode automatically.
Refer to Section 18-B-2.02 “Loading Procedure”
for further information.
• Starting up system administration from a remote
location can be done only in Dumb mode, so to
enter VT mode, press CTRL key + V key
simultaneously at the Dumb mode initial screen.
• The following operation describes how to access
the RMT card after accessing the PBX. For dial
access to the PBX from a remote location with a
modem, refer to the Operating Instructions of the
data terminal and modem.