Panasonic KX-TD500, Справочное руководство системы

Страница: 1511 / 1574

16-E-3
2.02 Port Test
This test verifies the status of the following functions for each port of the indicated
cards.
1. By entering physical port number (Except paired extension port and CO port)
PLC
HLC
DLC
DHLC
ATLC
DISA
AGC
OHCA Detect
Speech Path
HDLC
Speech Path
OHCA Detect
HDLC
HDLC
Speech Path
DTMF Receiver
Tone Detector
Speech Path
Repeater
Tone Detector
Port to be tested should be
“OUS” or “FAULT”.
Card Functions Remarks
2. By entering the physical port number of extension port and CO port in pairs.
LCOT
GCOT
RCOT
PCOT
SLC
HLC
MSLC
OPX
DHLC
ESLC
Speech Path
Loop Current
Bell Detect
DTMF Dial (DTMF Generator)
Pulse Dial
Speech Path
Bell
DTMF Detector (DTMF Receiver)
Pulse Detect
2 ports to be tested should
be “OUS” or “FAULT”.
SLC, HLC, OPX, MSLC,
DHLC, ESLC and DTMF
receiver to be tested should
be “OUS” or “FAULT”.
Card Functions Remarks
(Note)
• If you want to verify the status of the DTMF
receiver (1 or 2), change it's status to “Out of
Service” by entering OUS command and verify
the status of a card which contains DTMF
receivers.
SLC, HLC and OPX card contains two DTMF
receivers respectively.
For further information about OUS command,
refer to Section 16-C-1.02 “OUS command”.
• If trouble results from the card (not port), the
following message appears on the screen.
“Card Fault”
• This port test is available only for ports on the
following cards.
LCOT, GCOT, RCOT, PCOT, SLC, MSLC,
ESLC, DLC, DHLC, PLC, HLC, DISA, AGC,
OPX and ATLC cards.
• When you test the SLC, MSLC, ESLC, DLC,
DHLC, HLC, OPX, LCOT, RCOT, PCOT and
GCOT cards, change the status of both exten-
sion port and CO trunk port to OUS.