Panasonic 1M, Инструкции по эксплуатации, Страница: 61 / 134

After touching
, set the Security
Number using the following procedure.
On the Security Number Setting Screen,
touch for either of "Yes/Yes
(Only when an alarm sounds)"
Select one of "Yes/Yes (Only when an
alarm aounds)/No", and touch
Touch on the Setting
Screen
The Security Settings Screen is displayed.
For how to start the settings, please see
page 50.
This is for setting up the security function.
For the Security Alarm, see also ( pages 97 to 105).
61
Setup screen
Touch
Touch 2
Touch
any one
1
1
2
3
Yes (Only when
an alarm aounds.)
Yes
Security Setting
Security Number Screen
Security setting screen
Security Number Setting
Touch to go to 2/2
Touch to go to 1/2
Note
Touch
1
1
Continued on next page
Touch
any one
Touch
any one
Setting according to your preferences
On the Security Setting Screen, touch
for the content
you wish to set
For details on each
setting, please see
below.
● Be sure to take a note of the Security Number in the "Note of Security Number" on P48 as a reminder in
case you forget it.
● This cannot be set if there is no security function.
● The Security Number cannot be set or changed when the Security Alarm is in the set state.
Please disarm the Security Alarm before attempting to set or change the Security Number.
● The Security Number is set by selecting four digits between 0 and 9.
The Security Number must be entered
when the Security Alarm is disarmed.
The Security Number is only required
for the Security Alarm.
INTRODUCTION
USUAL USAGE
SETTING ACCORDING TO
YOUR PREFERENCES
OPERATIONS AND MEASURES
WHEN AN ALARM GOES OFF
OTHER
RECORD
MANAGEMENT
SECURITY ALARM SETTING
AND DISARMING
It is not necessary to enter the
Security Number for the
Security or Security Alarm.
No
factory default
setting
7.Windea̲取説（英語）̲1M.indd 61 7.Windea̲取説（英語）̲1M.indd 61 2012/09/06 17:03:39 2012/09/06 17:03:39