Painless PHANTOM KEY Series, Руководство пользователя

Страница: 22 / 30

22
Brown - this wire is an output wire from the module. This wire will provide a ground
source to the Park Light Flash relay whenever the Phantom Key is armed and
disarmed. The opposite end of this wire has been terminated and installed in the
Accessory relay base.
Connection of Relay Wires
At this point there are 4 remaining wires to connect to the vehicle in order to
complete the Phantom Key install. All 4 wires are power output wires from the relays
and are activated by the key fob.
Your particular install may only need one, two, three or all four wires depending
on your vehicle having power door locks, and/or if you have a component needing to be
power activated from the key fob, more details on that under the Yellow wire connection
instructions on the next page.
Brown - This wire will provide power to the park lights whenever the Phantom Key
module arms and disarms, giving you a visual confirmation the system is operating. This
Brown wire of the Phantom key harness will tap into a wire that has power when the
headlight switch is in the Park and in the headlight ON position.
Route this 16 gauge Brown wire, printed “From Park Flash Relay” towards the
headlight switch or to a park/marker light on the vehicle. If you are installing this
into a vehicle equipped with a Painless chassis harness the wire of the park light
circuit may have #927 printed on it. Do not get this Brown wire confused with the
Brown wire intended for the Ignition switch.