Painless PHANTOM KEY Series, Руководство пользователя

Страница: 24 / 30

24
CAUTION: AT THIS TIME THE BATTERY MAY BE
RECONNECTED. THE BATTERY SHOULD NOT TO BE
RECONNECTED UNTIL ALL CONNECTIONS HAVE BEEN
DOUBLE CHECKED AND ANY UNUSED WIRES OF THE
IGNITION SWITCH AND PHANTOM KEY MODULE HAVE THE
ENDS TAPED TO AVOID SHORTING TO GROUND.
KEY FOB MODES, INFORMATION, & OPERATION
The Key fob has 2 button that can control 3
different things: Lock, Unlock, and
Trunk/Hatch release (activation of the
accessory relay)
There are 2 different ways the key fob
identification can work with the module,
MANUAL and AUTOMATIC.
In MANUAL mode, a key fob button
must be pressed in order for the module to
identify the ID of the key fob and disarm the
system. This mode would be useful if you are in close proximity to the vehicle but do not
want the system to be functional. Examples of such situations would be at a car show, a
restaurant/building in which you may be seated close to the vehicle parked outside, or
for your own peace of mind knowing you have full control of the system.
In AUTOMATIC mode the module detects the key fob ID signal on its own as
soon as the key fob is within range. In AUTOMATIC mode you simply approach the
vehicle and the system disarms causing the stainless button to become active.
To check the mode your key fob is currently in:
Push and hold both buttons on the key fob simultaneously until the LED goes
out, about 6 seconds, then release
Upon release of the buttons the LED will flash to indicate which mode you are in.
3 flashes=AUTOMATIC 5 flashes = MANUAL
To change the mode your key fob is currently in: