Optek CONTROL 200, Инструкция по эксплуатации

Страница: 31 / 135

C200 S
OFTWARE
Instruction Manual C200 Part2 A1.doc
optek Danulat GmbH • D-45356 Essen • Germany page 9
CONFIG.ALARMS Config. Alarm 1
A1: Type
A1: Assign
A1: Failsafe
A1: Action
A1: Setpoint
A1: Hysteresis
A1: Delay
Config. Alarm 2
A2: Type
A2: Assign
A2: Failsafe
A2: Action
A2: Setpoint
A2: Hysteresis
A2: Delay
A3: Assign
A3: Failsafe
A3: Action
A3: Setpoint
A3: Hysteresis
A3: Delay
To
FACTORY SETTINGS
(see Section 7.3, Page 57)
Config. Alarm 3
A3: Type
Key
Use the Sidescroll Key to scroll through the Pages within each Menu
Section 5.5, Page 34
Use the Downscroll
Key to scroll through
the Frames
within each Page
Config. Alarm 4
A4: Type
A4: Assign
A4: Failsafe
A4: Action
A4: Setpoint
A4: Hysteresis
A4: Delay
Config. Alarm 5
A5: Type
A5: Assign
A5: Failsafe
A5: Action
A5: Setpoint
A5: Hysteresis
A5: Delay
Wash Frequency
Wash Duration
Recovery Period
Wash Mode
*
*
Applicable only
to Alarm 3
CONFIG.LOGBOOK
Section 5.9, Page 41
Logbook
CONFIG.SECURITY Alter Sec.Code
Alter Cal.Code
Section 5.8, Page 41
CONFIG.CLOCK Set Clock?
Format dd/mm/yy
Date 01:01:02
Time 12:00
Press To Abort Press To Set
Section 5.7, Page 40
Use the Menu Key
to scroll through
the Menus
CONFIG.OUTPUTS Config. Output 1
AO1: Assign
AO1: Range
AO1: Span Value
AO1: Zero Value
AO1: Default
AO1: Default Val
Config. Output 2
AO2: Assign
AO2: Range
AO2: Span Value
AO2: Zero Value
AO2: Default
AO2: Default Val
Config. Output 3
AO3: Assign
AO3: Range
AO3: Span Value
AO3: Zero Value
AO3: Default
AO3: Default Val
Section 5.6, Page 38
Config. Output 4
AO4: Assign
AO4: Range
AO4: Span Value
AO4: Zero Value
AO4: Default
AO4: Default Val
Single Input Analyzer Only — see PID Control Supplement (IM/AX4PID)
CONFIG. CONTROL
TEST/MAINTENANCE
Test Outputs
Test Output 1
Test Output 2
Maintenance
Hold Outputs
Test Output 3
Test Output 4
Section 5.10, Page 42
Load/Save Config
Factory Config.
User Config.
Press To Abort Press To Set
CONFIG.SERIAL
Applicable only if Option Board fitted and Serial Communications feature enabled (Section 7.3) –
see PROFIBUS Datalink Description ABB PROFIBUS-Enabled Products, IM/PROBUS
Available only if the Option Board
is fitted and Analog features
enabled – see Section 7.3
5.1.5, Page 49
5.1.6, Page 53
5.1.7, Page 55
5.1.8, Page 56
5.2.9, Page 83
5.1.10, Page 57
6.1.3, Page 88)