Optek CONTROL 200, Инструкция по эксплуатации

Страница: 54 / 135

C200 S
OFTWARE
Instruction Manual C200 Part2 A1.doc optek Danulat GmbH • D-45356 Essen • Germany page 32
4 Setup
4.1
Sensor Calibration pH
Note. If Probe Type for either sensor (Sensor A only if single input) is set to Redox or ORP, the sensor can be
calibrated only if Enable Cals. for that sensor is set to Yes – see Section 5.1.4.
Sensor Calibration
Sensor Calibration Security Code
Enter the required code number (between 0000 and 19999) to access the sensor
calibration pages. If an incorrect value is entered, access to the calibration pages is
prevented and the display reverts to the SENSOR CAL. menu.
Note. Applicable only if Alter Cal. Code is not set to zero – see Section 5.1.8.
Probe Type set to pH (for either sensor if dual input analyzer – see
Section 5.1.3) – continued below.
Probe Type set to Redox or ORP (for both sensors if dual input
analyzer – see Section 5.1.3) – continued on page 32.
4.1.1 Set Buffer Type (pH Only
Set Auto Buffers
Continued on Page 32.
Alter Sec. Code not set to zero (Section 5.1.8) – see Section 5.1.1.
Alter Sec. Code set to zero (Section 5.1.8) – see Section 5.2.
Continued below.
Buffer Type
Select the relevant type of buffer solution (see Appendix 8.1):
ABB – ABB supplied buffer solution.
NIST – NIST buffer solution.
DIN – DIN 19266 buffer solution.
MERCK – MERCK buffer solution
TECH
– US Technical buffer solution
User – Buffer solution with a user defined pH value – see Section 4.1.2.
Buffer Type not set to User – continued on next page.
Buffer Type set to User – see Section 4.1.2.
SENSOR CAL.
-----
Cal. User Code
0000
Set Auto Buffers
Sensor Cal. A
Set Auto Buffers
-----
Sensor Cal. A
SECURITY CODE
CONFIG. DISPLAY
Buffer Type
-----
User
TECH.
MERC
K
DIN
NIST
ABB
Set Buffer 1
Buffer Type
A: Enter Point 1