v1.12
Cloudberry Management – PTP Management User Manual
- 15 -
1.2.8.2
Configure device
1.2.8.2.1
PTP Settings
In this menu you can configure PTP parameters. You may change values in the menu without
it being stored to CM-1600. Blue fields are fields with changes which have not been stored to
CM-1600.
In order to save the new configuration, press the: “Set” button. You shall receive confirmation
by a popup dialog if the new settings are stored correctly and all fields shall be white.
However, the settings are not applied to the running configuration. In order to run with the
new settings the PTP CPU must be rebooted. The “Reboot PTP CPU” button will force a
reboot of the PTP CPU. Note that the switch functionality of CM-1600 will run unaffected by a
reboot of the PTP CPU.
The refresh button will force a read of the values for the relevant CM-1600.
Store config
: Press “set”
Apply config
: Press the “Reboot PTP CPU” after a “Set” (The PTP CPU will reboot and use
new settings when it boots up)
Refresh
: Force a new read of the stored values on CM-1600 (Note: These are the stored
values of the device and not necessarily running values)
