![background image](http://html1.mh-extra.com/html/omron/scara-r6y-xc-series/scara-r6y-xc-series_user-manual_743986124.webp)
4-20
CHAPTER 4 Adjustment
8-3
Adjusting the belt tension (R6YXC700,R6YXC800,R6YXC1000)
Adjust the Z-axis and R-axis timing belts of the R6YXC700, R6YXC800 and
R6YXC1000 with the procedure below.
1) Prepare the necessary tools.
• Push-pull scale
• Stay (See Fig. 4-11. This stay should be prepared by the user.)
• Hex wrench set
• Phillips-head screwdriver
• Scale
2) Turn off the controller.
3) Place a sign indicating the robot is being adjusted, to keep others from
operating the controller switch.
4) Enter the safeguard enclosure.
5) Remove the Y-axis upper and under covers.
Refer to “7 Removing the Robot Covers” in Chapter 4 for removing the covers.
Place the upper cover on the robot base (pedestal) side with the machine
harness still connected.
6) Prop the spline or end effector with a support stand to prevent the Z-axis
from dropping (when adjusting the Z-axis belt tension).
7) Adjust the belt tension by two people as follows.
Using the push-pull scale, one person applies a load perpendicular to the
middle of the belt. The other person checks the slack of the belt. (See
Figs. 4-10 and 4-11.)
8) The correct load to be applied to the belt of each robot model and the
resulting slack are shown in Tables 4-5 and 4-6. When the load producing
the specified slack is within this range, no adjustment is required. If not,
adjust the tension with the following procedure.
(1) Z-axis belt adjustment
1. Loosen the bolt 1 shown in Fig. 4-14.
2. If the load producing the slack specified in Table 4-5 (step 7) above) is
smaller than the specified range, move the Z-axis motor in the direction
increasing the tension. If the load is greater than this, move it in the
direction reducing the tension. Then, retighten the bolt.
3. Recheck the belt tension using the same procedure in step 7). When the
load applied to produce the specified slack is within the specified range
of Table 4-5, the adjustment is okay. If not, repeat the above procedure
from steps 1 to 3.
WARNING
IF THE Z-AXIS PULLEY COMES OFF THE Z-AXIS BELT, THE Z-AXIS
DROPS CAUSING A HAZARDOUS SITUATION. TURN OFF THE
CONTROLLER AND BE SURE TO PROP THE Z-AXIS WITH A SUPPORT
STAND BEFORE BEGINNING ADJUSTMENT.
Содержание SCARA R6Y-XC Series
