Omron CS1W-SLK11-21 - 06-2004, Руководство пользователя

Страница: 157 / 202

140
Error Log Section 8-2
0109
Hex Transmission failed; destination
busy Command block
Bits 0 to 7:
Source node address
Bits 8 to 14:
Source Network address
Bit 15:
OFF
Response block
Bits 0 to 7:
Destination node address
Bits 8 to 14:
Destination Network
address
Bit 15:
ON
(1st byte: bits 8 to 15;
2nd byte, bits 0 to 7)
Set the data link tables com-
munications cycle time auto-
matically, or increase the
settings manually. No
010A
Hex Transmission failed; communica-
tions controller error Conduct an echoback test
and if the effects of noise are
considerable, reconsider the
operating environment.
Restart the SYSMAC LINK
Unit. If the error occurs again,
replace the Unit. Yes
010B
Hex Transmission failed; PLC error Refer to the PLC operating
manual. If the error occurs
again, replace the PLC. No
010C
Hex Transmission failed; unit number
incorrect Check unit number settings to
be sure they are within range
and unique. No
010D
Hex Transmission failed; destination
address incorrect Check routing tables. No
010E
Hex Transmission failed; routing
tables not registered Check routing tables. No
010F
Hex Transmission failed; routing table
error Check routing tables. No
0110
Hex Transmission failed; too many
relay points Check routing tables and sys-
tem configuration. Do not try
to access Networks sepa-
rated by more than one other
Network. No
0111
Hex Transmission failed; command
packet too long Be sure to use the FINS com-
mand format. No
0112
Hex Transmission failed; header
error. Be sure to use the correct
FINS command format. No
0113
Hex Transmission failed; I/O setting
error Check I/O table accuracy. No
0114
Hex Transmission failed; CPU bus
error Check Unit and cable connec-
tions and clear error. No
0115
Hex Transmission failed; redundant I/
O allocations Check unit numbers for
redundancy within the same
PLC. No
0116
Hex Transmission failed; CPU Bus
Unit error Check Unit and cable connec-
tions and clear error. No
Error
code
Contents Detail code Correction Written to
EEPROM
1st byte 2nd byte