Olympus AL120-12 Series, Руководство по обслуживанию, Страница: 10 / 68

Introduction
/Before Starting Operations
Operation/Maintenance Manual
i-8
Page
3. Before Starting Operations
In order to get the best performance from the loader, as well as to ensure safety, please follow the 3
points listed below.
1. Never put your hands in the loader.
2. Do not deliberately place wafers or other objects in or remove from the loader
while it is in operation.
If excess force is applied to the wafer under inspection, it could lose its
adhesiveness and could be damaged.
3. Make sure that the main switch is turned off before removing a wafer for
unavoidable reasons such as malfunctions.
4. Maintenance and Storage
Be sure to set the main stich to
○
(OFF) and disconnect the power cord from the
back side of the loader before starting following operations.
1. Wipe each part of the loader using a soft cloth moistened with pure water.
Wipe heavy dirt or stains with a clean paper moistened with commercially
available absolute alcohol.
Never place absolute alcohol close to a flame as it is highly flammable.
Take care not to cause sparks by turning on or off an electric appliance or
fluorescent lamp.
2. Wear gloves to protect your hands while cleaning the loader when for example a
wafer is damaged.
3. Periodically check the loader for wear (a wafer loading arm and deterioration of
the drive mechanism), and replace the parts as needed. Contact your nearest
OLYMPUS distributor for repair.
1. Never disassemble the loader unnecessarily. This could affect the performance
and function of the loader.
2. Contact your nearest OLYMPUS distributor if you need MSDS.
3. Confirm and observe your local municipal ordinances or regulations when you
dispose of the loader.
If you have any questions, contact your nearest OLYMPUS distributor.
4. Lenses and solders used by this system are lead-free.
ＣＡＵＴＩＯＮ
ＣＡＵＴＩＯＮ
ＮＯＴＩＣＥ