Oce Arizona 500, Руководство пользователя

Страница: 92 / 156

Océ | Printer Maintenance
5-4
Automated Maintenance
The Arizona 500 printer firmware performs automated maintenance without direct
operator intervention when the printer is powered On and while printing. These types of
maintenance and duration parameters are set at the factory.
5.3.1
Warm-Up Maintenance (Idle Purge)
When the printer has been idle for a set duration of time, a low purge is performed before
the next print. The default time duration for a low purge is 10 minutes. The default time
duration for a high purge is 30 minutes. These default values are not user changeable.
Print Heads Clean the nozzle plates with a lint-free swab
and cleaning solution/fluid according to the
Print Head Maintenance and Nozzle Recovery
Procedures document (see “Print Head Main-
tenance and Nozzle Recovery Procedures” on
page B-1).
Use the Operator/Maintenance Menu to purge
print heads. (
Note: Media must be installed
prior to performing a purge.)
Daily
As required
System Air Filters Periodically inspect and replace the four sys-
tem air filters (see “System Filters” on page 5-
15). Every 60 days
or as required
Vacuum Platen Wipe clean with a lint-free cloth and alcohol or
cleaning solution/fluid.
Cover the open ends with paper to improve
the vacuum when narrow media is in use. Every media
change
As required
Ventilation and
Drying Ensure that the airflow and ducting meet pub-
lished site survey requirements. Every 60 days
Important:
If isopropyl alcohol does not remove ink stains, use only the approved
cleaning solution/fluid supplied with the printer in very small quantities.
Do not use cleaning solution/fluid on the Plexiglas windows. Always use
protective gloves, eye protectors, and a lint-free cloth when handling
solvent-based solutions.
Description Procedure Frequency