Oce Arizona 500, Руководство пользователя

Страница: 42 / 156

Océ | Media System
3-16
• Positioning of the Print & Go external media take-up unit (EMTU) square to
the front of the Arizona 500 printer
Inexact installation may result in media encoder errors, the misreading of the media width,
media rippling and/or head strikes.
3.4.1
Installing Supply Media
Follow the steps below to install a new supply media roll:
1. Install the supply media on the mandrel (see Figure 3-3), ensuring that the media is
centered (see Figure 3-4), and secure the locking hubs.
2. Lower the mandrel assembly support arms on both sides of the frame and place the
mandrel/media assembly into the machine (see Figure 3-5). Make sure the mandrel is
seated properly on the gear and steel rollers (see Figure 3-6)
.
3. Lock the mandrel on both sides of the frame.
4. Gently close the rear door completely.
3.4.2
Loading New Supply Roll
Follow the steps below for loading a new supply media roll:
1. Press the Load Media button. You then see:
Load Media
new supply roll?
2. Press the ACCEPT button. You then see:
Print label:
Off
Use the + button to toggle between OFF and ON.
3. Press ACCEPT. You then see:
Use +/- keys, attach
takeup, press ACCEPT
4. Feed the media over the supply dancer roller and into the vacuum platen area. To
keep the media from falling back, gently feed the media down between the back wall
and the supply dancer assembly (see Figure 3-7).
5. If not already open, gently open the front door completely, and pull the pinch roller
handle to disengage the rollers (see Figure 3-8).