the shaft (see the diagram below). This allows you to print on the "back"
side of the media.
When to do
This section explains how to load new media when none is currently
loaded. If media is already loaded, first read the section How to Cut and
Unload Media.
Before you begin
It is very important that the media is wound properly onto the core when it
arrives from the manufacturer. The media must be wound straight, tight
and even from one end to the other. If you have a roll that is not even,
before loading it, hold the roll in a vertical position and carefully and
evenly drop one end onto the floor, then tap lightly a few times. If any
edges are crushed, unwind and throw away the crushed area or cut off the
crushed end of roll. If is not possible to repair, do not use it.
NOTE
If media has been stored on its side and has a pronounced flat side, do
not use it as it will not advance evenly.
Required tools
5mm hex key
Load Supply Media Roll and Position a Take-up Shaft
Procedure
1.
Place an empty media shaft on a suitable flat work area, positioned as
shown, so that the 5mm hex key is inserted on the right side of the shaft to
lock and unlock the core locks.
How to Load Media
Chapter 7 - How to Operate the Roll Media Option
123
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
