NOTE
Maintenance Station Switches:
There are three switches inside of the maintenance station . They can be
operated in any order. For example, you can press the middle switch to
raise the carriage to remove debris from the underside of the carriage
even when a purge isn't required.
[125] Maintenance Station Switches
Left switch to activate
suction pump
Middle switch to raise
carriage
Right switch to start
an ink purge
Procedure
1.
Verify that the ink temperature is at least 40° Centigrade (104° Fahrenheit)
before you begin printhead maintenance.
2.
Slide the drawer out from under the carriage to reveal the maintenance
station.
3.
Press the Purge button to initiate a purge. The carriage will lower to its
purge height (4mm above the table surface). Watch the ink as it falls from
the heads. After a few seconds most of the ink stops dripping and you can
then raise the carriage.
4.
Press the middle button to raise the carriage to its maximum height.
How To Perform Printhead Maintenance
Chapter 12 - Printer Maintenance
229
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
