NOTE
Do not let the plastic edge near the arc butt up against the media edge or
the device may not let the media pass smoothly.
The vacuum in the platen will hold the main part of the protector in place
while the image is printed.
7.
Press down on the tape to fasten the protector in this position.
[79] Edge Protector in Position
NOTE
The adhesive on the edge protector can be re-used approximately ten
times. If you find that it is not holding the protector in place, then use a
new one.
Result
The media edge protectors will reduce the amount of fiber and other
debris. However, it is important to keep the platen and cutting guide areas
clean as indicated in the Roll Media maintenance section.
How to Deal with Wide Media
If you use media of the maximum width for the RMO (2.2m or 7.2 feet) that
requires media edge protection, you can cut the protectors in half in order
for them to fit.
How to Use Media Edge Protectors
Chapter 7 - How to Operate the Roll Media Option
143
User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013
