Q-Code User Manual
Ver. 7.0 2021/11/30
81
b) 50%: Output 50% current.
c) 83%: Output 83% current.
d) 100%: Output 100% current.
Initial:
Set the initial output voltage.
a) High: Set the initial output type as Output High.
b) Low: Set the initial output type as Output Low.
Busy:
Set the output of Action signals.
a) Low: Set Action as Active Low (Sink Output).
b) High: Action as Active High (Drive Output).
Note:
1. For NY5, I/O pin must use IO_Pull-High to use as input pin. If I/O pin is as input pin and not
switching to output mode, the system won’t enter sleep mode as pin is pressed.
To use I/O pin as output, it must be set as Normal current output and Initial Low, and only
support Sink output.
2. NY4 / NY5 / NY5+ / NY6 / NY7 do not support Output Type / Connect Type / Current options.
3. NX1 does not support Output Type / Connect Type options.
4. NY4 / NY5+ / NY6 / NY7 / NY9T / NX1 do not support IO Pull-High and IO Open-Drain.
5. NY4 / NY5 / NY5+ do not support CS Current option.
6. The table of NY9T pins corresponding with output current is shown below.
NY9T001A
NY9T004A
NY9T008A
NY9T016A
Constant Drive
PE.1 ~ PE.2
Not Available
PE.2
Not Available
Constant Sink
PE.0 ~ PE.2
PE.0 ~ PE.3
PE.0 ~ PF.3
PE.0 ~ PF.3
[Path]
TR1: PA=0xF
; Open Pull-High resistor of PA.0, PA.1.
TR2: PA=0x0
; Close Pull-High resistor of PA.0, PA.1.
Operating steps: I/O
→Direct→OK
, as shown in the following figure.
Click
Direct
and the following dialog box will appear: