Q-Code User Manual
Ver. 7.0 2021/11/30
48
Touch-Key when the it is pressed, to avoid touching the edge of the pad may
cause the Touch-Key in an unstable state. (Default=Small) NX1 doesn’t support
this option.
Ex.
TouchKey_Hysteresis_Level
= Disable
;
Do not adjust the sensitivity level after
Touch-Key is pressed.
Ex.
TouchKey_Hysteresis_Level
= Small
; Adjust the sensitivity one level higher after
Touch-Key is pressed.
Ex.
TouchKey_Hysteresis_Level
= Large
; Increase the sensitivity up to 50% after
Touch-Key is pressed.
Note:
1. Usually the touched site is far away from the touch pin of IC or the Touch-Key is
sensitive, will need to execute the function. Users can actually use the product to
decide which one to set.
2. NY9T004A does not support Hysteresis Level function.
Idle To Sleep:
The period for entering the sleep mode. This option can adjust the idle time for
entering sleep. NX1 supports 1~16 seconds ( default is 8 seconds).
Ex.
TouchKey_
IdleToSleep
= 7s
; After 7 seconds of un-triggered, enter the sleep mode
Note: NY9T doesn’t support this option.
3.9.1.8 Reset
NY4 / NY5+
This feature is for configuring pin for externally resetting IC. User
can select Pull-High (Weak / Strong ) or Floating as Reset pin. If the
“Floating” is selected, the external connection of 1M resistance is
required (default value is Disable).
Ex.
Reset
= P:W
; Pull-High Weak Resistor
Ex.
Reset
= P:S
; Pull-High Strong Resistor
Ex.
Reset
= F
; Floating
For NY5+, user can select the target pin as Reset pin, but for NY4, the pin of Reset pin is fixed.
Ex.
Reset_Pin
=
PA.3